From geraldo.cc.utexas.edu!cs.utexas.edu!zaphod.mps.ohio-state.edu!malgudi.oar.net!sun!vax.cns.muskingum.edu!kimple Mon Mar 8 13:33:58 CST 1993
Article: 2053 of rec.music.makers.guitar
Path: geraldo.cc.utexas.edu!cs.utexas.edu!zaphod.mps.ohio-state.edu!malgudi.oar.net!sun!vax.cns.muskingum.edu!kimple
From: kimpl–(at)–ax.cns.muskingum.edu
Newsgroups: rec.music.makers.guitar
Subject: Re: MOD: Midrange control for Fenders, BEG LEVEL
Message-ID: <1993Mar8.111531.471--(at)--ax.cns.muskingum.edu>
Date: 8 Mar 93 11:15:31 -0500
References: <1993Mar5.172354.469--(at)--ax.cns.muskingum.edu>
Organization: Muskingum College
Lines: 17

In article <1993Mar5.172354.469--(at)--ax.cns.muskingum.edu>, kimpl–(at)–ax.cns.muskingum.edu writes:
> Here’s an easy one: adding a midrange control to Fender amps that have no
> midrange control. (Tube amps)
>
> On the left hand tab of the Bass control (looking at it from the back) is a
> 6.8k resistor. This is Fender’s ‘fixed’ midrange. Replace it with a 10Kohm
> potentiometer, and that’s it! If you want a ‘boosted’ midrange, you may want to
> try a 25Kohm pot.

Well…I’ve been a bit vague here…that’s what I get for doing this while
sick…but anyways…
The resistor goes from the left hand tab of the pot to ground. when replacing
this, run a wire from the left hand tab of the bass pot, to the middle tab of
the midrange pot. The left hand tab of the midrange pot should then be wired
to ground.

jd