I've found some starter kits for those who wish to make a JT-30 from scratch. These are all original Astatic parts (except for the screws - from the local hardware store). If you can work with a soldering gun and can drill out soft metal, you can come up with a good harp mic staring with these kits.



These are the orginal
Zinc Alloy Bodies. They have been painted black. Astatic now puts the Volume
control into the place where traditionally the connector is supposed to go.
The hole is drilled out to 3/8" for the Astatic volume control. I would
suggest drilling this hole out to 1/2" and putting in a deep panel 1/4
phone jack so you can plug the guitar cord directly into the mic. You can also
take a good length of guitar cord and cut one end off and snake it through this
hole and have a permanent cord.
Astatic glues the XLR connector into the larger hole. I prefer to drill out
a 1/4" or 3/8" hole in this hole and put the volume control there.
Putting the cord connector towards the back of the mic makes it easier to hold.
Another place for the volume control is the back end of the mic, the pointy
end of the egg. Here the metal is fairly thin and you can put a pot there and
have the control out of the way of your hands so that it won't disturb the way
you cup the mic.


These are original
chrome plated grills which fit the shells. They are new, so they are not as
heavy or as cleanly cast as the old mics, but they are the best you can get
in the 21st century.
You can buy them as part of a kit or you can order the grill separately. They make a good replacement for the old grills where the chrome has worn away or they have broken. They make great belt buckles, Christmas Tree ornaments or garish bolo ties.
Get them from Erica's JT-30 Boutique.